Falcon Handpiece Set Up - Chattanooga 2176KIT User Manual

19
SETUP INSTRUCTIONS

FALCON HANDPIECE SET UP

1. Unscrew the shaft from the handpiece and pull it out of the
handpiece handle. Use the supplied open-end spanner for this
purpose.
2. Insert the new projectile into the fitted guiding tube
INTELECT RPW 2 USER MANUAL
®
3. Screw the shaft into the handpiece until finger-tight. Using one
hand, press the handpiece firmly onto the table and tighten the
shaft using the open-end spanner. It must no longer be possible
to unscrew the shaft by hand.
4. Screw the transmitter screw cap with the required transmitter
firmly back onto the shaft. For two-part transmitter caps: Make
sure that the two cap parts are screwed firmly in place and that
the transmitter screw cap is screwed firmly to the shaft.
5. Connect the Falcon handpiece to the right connector on the
device
E N