Mixer Channel Control - Nektar PANORAMA CS12 Owner's Manual

The mixer channel controls are assigned to the main mixer parameters.
1. Fader
The 100mm long-throw motorized fader is assigned by default to control the selected
Logic Pro mixer channel's volume. With a control resolution of 10 bit, the fader is
capable of detailed control. Select a channel and the fader jumps to that channels
volume position.
Fine Control: The fader can control parameters at 14 bit resolution. Hold the Fine
(magnifier) button while moving the fader. To reposition the fader without affecting
the parameter, hold [Fine]+[Mute] and move the fader.
For more information, see the section
Master Volume: Press [Shift]+[Select] to control Logic Pro's Master Volume. Repeat to
toggle fader modes: Selected Channel/Master.
Setting volume to 0 db: Hold [Shift]+[touch the fader]
Temporarily disable fader motor: Hold [Select]+[touch the fader]. Touch the fader again to re-enable.
2. Meter
The 6 segment stereo meter shows the channel level from -60db to clipping. If a mono channel is selected, only
the left column is used. From -60db, the first 4 green segment gradually increases in illumination until -9db. The
5th yellow and 6th red segments gradually increase in illumination from -9db to 0 db.
3. Pan
The rotary pot controls Pan. The pots RGB LED color is set by the channel strip color in Logic Pro. To change it in
Logic Pro, open the Mixer and right-click on the color label. Next select a new color from the pallet.
The Logic Pro channel color also illuminates the Channel and Sends buttons.
4. Arm button
[Arm] is red if the current track is enabled for record. If record is enabled on a channel other than the selected,
the button is white and pressing [Arm] enables record again. Press [Shift]+[Arm] to disable record on all other
tracks.
5. Solo button
Activate (green)/deactivate (white) solo on the current channel. Press [Shift]+[Solo] to toggle all channels with
solo active, off and on.
6. Mute button
Activate (orange)/deactivate (white) channel mute. Press [Shift]+[Mute] to disable mute on all muted channels.
7. Select button:
See next page.
MIXER CHANNEL CONTROLS
Fine - High Resolution Control on page
1
17.
CS12
PANORAMA
Channel Strip Controller
8_PAGE
2
3
4
5
6
7