Related Manuals for Technicolor CGA0112
Summary of Contents for Technicolor CGA0112
- Page 1 CGA0112 DOCSIS 3.0 Wireless Cable modem Router ’ ’ Revision 1.0 Dec 2018...
- Page 2 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 3 User’s Manual...
- Page 4 CGA0112 Cable Modem User’s Manual Canada-Industry Canada (IC) Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE:...
-
Page 5: Table Of Contents
Table of Contents 1. INTRODUCTION ....................1 1.1 ....................... 1 EATURES 1.2 ................. 1 YSTEM EQUIREMENTS 1.3 ................. 1 NPACKING AND NSPECTION 1.4 ..................2 AFETY RECAUTIONS 2. HARDWARE OVERVIEW ................3 2.1 ................3 RONT ANEL AND 3. ETHERNET INSTALLATION ................6 4. -
Page 7: Introduction
CGA0112 -to-Phone, Phone-to- CGA0112 And with the integration of 2 ports switch and IEEE 802.11n wireless functionality, the CGA0112 could also be used as a Wireless Cable Modem Residential Gateway in your home or small office. The ability to route data information into your broadband network could help you easily extend your local network via wire or wireless. -
Page 8: Safety Precautions
CGA0112 Cable Modem User’s Manual 1 x Quick Installation Guide 1 x RJ-45 CAT 5 Cable 1 x 12V/1.75A Power Supply Adaptor 1 x 6P4C Telephone Cord If any of above items lost or damaged, please contact your retailer or ISP for assistance. -
Page 9: Hardware Overview
User’s Manual Hardware Overview Front Panel and LEDs There are ten Light-Emitting-Diodes (LEDs) located on the front panel top provide status information to the user. NAME COLOR MODE STATUS DC Power is connected Green No DC Power connected Blinking Downstream scanning Green Downstream locked Cable interface idle or W/DS bonding... - Page 10 CGA0112 Cable Modem User’s Manual No ETH device connected WiFi enable WLAN 2.4GHz & Green WiFi disable Blinking Data in traffic Blinking WPS in paring Green WPS enabled WPS disabled TEL1 on-hook TEL1 Green TEL1 disable blinking TEL1 provisioning or off-hook 2.2 Rear Panel and Hardware Connection...
- Page 11 User’s Manual Step 1: Connect a cable by feeding the F-connector on the back of the cable modem. Ensure the center conductor of the 75 ohm coaxial cable is inserted directly into the center of the F-connector. Secure the coaxial cable by carefully threading the outer shell of the coaxial cable connector onto the F-connector in a clockwise direction until tight.
-
Page 12: Ethernet Installation
CGA0112 Cable Modem User’s Manual Ethernet Installation The LAN port you are using is auto-negotiating 10/100/1000Mbps (Switch) Ethernet Interface. You can use the Ethernet port to connect to the Internet with an Ethernet network device such as NIC/Hub/Switch through RJ45. -
Page 13: Web Management
You may get an error message. This is normal. Continue on to the next step. Type the default IP address of the CGA0112 (e.g. 192.168.0.1) and press Enter. The Log In page appears. Type the user name (admin) and your password (password) in the respective fields. -
Page 14: Status
The Basic page contains the basic features of CGA0112 including Setup, DHCP and Backup 4.3.1 DHCP The DHCP page allows you to activate/deactivate the DHCP server function of the CGA0112 , and, if the DHCP server is activated, to see DHCP leases it has provided. -
Page 15: Advanced
User’s Manual With this function activated, your cable service provider’s DHCP server provides one IP address for the CGA0112 , and the CGA0112 ’s DHCP server provides IP addresses, starting at the address you set in Starting Local Address field, to your PCs. A DHCP server leases an IP address with an expiration time. -
Page 16: Ip Filtering
WAN Blocking: To prevent others on the WAN side from being able to ping your CGA0112 . With WAN Blocking on, your CGA0112 will not respond to pings it receives, effectively “hiding” your gateway. Ipsec PassThrough: To enable IpSec type packets to pass through between WAN and LAN. -
Page 17: Mac Filtering
These PCs can still communicate with each other on your LAN, but packets they originate to WAN addresses are blocked by the CGA0112 . To enable IP Filtering feature of CGA0112 , check the Enable box and click Apply button. -
Page 18: Port Filtering
4.4.5 Forwarding For communications between LAN and WAN, the CGA0112 normally only allows you to originate an IP connection with a PC on the WAN; it will ignore attempts of the WAN PC to originate a connection onto your PC. This protects you from malicious attacks from outsiders. -
Page 19: Port Triggers
User’s Manual Using the Port Forwarding page, you can provide local services (web servers, FTP servers, mail servers, etc) for people on the Internet or play Internet games. A table of commonly used port numbers is also provided. 4.4.6 Port Triggers The Port Triggers page allows you to configure dynamic triggers to specific devices on the LAN. -
Page 20: Dmz Host
HTTP server on this machine, anyone will be able to access that HTTP server by using your CGA0112 ’s IP address as the destination. This may be used when problem applications do not work with port triggers. The... -
Page 21: Firewall
User’s Manual Firewall The CGA0112 provides built-in firewall functions, enabling you to protect the system against denial of service (DoS) attacks and other unwelcome or malicious accesses to your LAN. 4.5.1 Local Log The Local Log page allows you to configure the firewall event log reported via email alert, and these attack records are also visible in the table on the bottom of this page. -
Page 22: Parental Control
CGA0112 Cable Modem User’s Manual Parental Control 4.6.1 User Setup This page allows configuration of users. “White List Only” feature limits the user to visit only the sites, specified in the Allowed Domain List of his/her content rule. 4.6.2 Basic Setup This page allows basic selections of rules which block certain Internet content and certain Web sites. -
Page 23: Wireless
User’s Manual 4.6.4 Event Log This page displays Parental Control event log reporting. Wireless 4.7.1 Radio The Wireless Connection Stage Configuration of the Wireless Radio includes current country and channel number. 4.7.2 802.11 Primary Network The 802.11 Primary Network allows configuration of the Primary Wireless Network and its security settings. -
Page 24: Access Control
CGA0112 Cable Modem User’s Manual 4.7.3 Access Control This page allows configuration of the Access Control to the AP as well as on the connected clients. 4.7.4 Advanced This page allows configuration of data rates and WiFi thresholds. -
Page 25: Bridging
User’s Manual 4.7.5 Bridging This page allows configuration of WDS features. 4.7.6 WMM This page allows configuration of the Wi-Fi Multimedia QoS. -
Page 26: Guest Network
CGA0112 Cable Modem User’s Manual 4.7.7 Guest Network This page allows configuration of a guest network.. -
Page 27: Mta
User’s Manual Section MTA has 5 sub-items, which indicate the status of MTA. These information can help you to understand the parameters of MTA operation. 4.8.1 Status This page displays initialization status of the MTA. is document is subject to change without notice.
Need help?
Do you have a question about the CGA0112 and is the answer not in the manual?
Questions and answers