Page 1
Energy Star Rated Dehumidifier 22 Pint, 50 Pint and 50 Pint with Pump Model Numbers: HME1001 HME1003 HME1004 Thank you for purchasing our appliance. Please be sure to read the entirety of this user manual carefully prior to using this appliance. If you have any questions...
Failure to keep the product in its original quality from the time of receipt may impede hOmeLabs’s ability to correct any legitimate problem and may limit the extent to which hOmeLabs may provide recourse.
ELECTRICAL INFORMATION IMPORTANT NOTICE FOR FIRST TIME USE • The hOmeLabs nameplate is located on the rear panel of the Dehumidifier and contains electrical and other technical data specific to this Dehumidifier. • Be sure the Dehumidifier is properly grounded. To minimize shock and fire hazards, proper grounding is important.
Page 4
Important Safety Instructions Important Safety Instructions • Be aware! Refrigerants may not contain an odor. Contact Customer Support immediately if you believe your unit contains or used to contain flammable refrigerant shall use any sources of ignition in such a manner that has a refrigerant leak.
Page 5
Important Safety Instructions Important Safety Instructions CONTROL PANEL (CONT.) 8. Repair to Intrinsically Safe Components Prior to recharging the system, the pressure test with OFN must first be conducted. Do not apply any permanent inductive or capacitive loads to the circuit without ensuring that this will not exceed The system leak test shall be performed upon completion of charging, but should be done prior the permissible voltage and current for the unit in use.
Parts Description Operation FRONT PLACEMENT REAR More than Control Panel • This unit may have been tilted or placed upside down during Handle 15.75 in (40 cm) (Both Sides) shipping. To ensure this device works properly, allow unit to sit upright for at least 24 hours before initial use. Air Outlet Grille More than Air intake Grille / Air Filter...
Operation Operation CONTROL PANEL CONTROL PANEL (CONT.) “Continuous” button “Left”/”Right” buttons Press to activate the continuous dehumidifying operation. The appliance will work continuously NOTE: and will not stop except that the Bucket is full. When the Dehumidifier is first turned on, In “Continuous”...
Page 8
Operation Operation REMOVING THE COLLECTED WATER ELECTRICAL INFORMATION REMOVING THE COLLECTED WATER (CONT.) 3. Pump Draining (Only applicable to HME1004) 1. Use the Bucket • Remove the Continuous Drain Hose from the unit. NOTE: NOTE: When the Bucket is full, remove the Bucket Replace the plastic cover of the Continuous Drain Do not use “Continuous Draining”...
You only need to empty the Bucket manually to clean it or for storage. clog it and reduce performance. The Pump Hose Drops must be in water to function. Please contact Customer Service at homelabs.com/help or help@homelabs.com if Dehumidifier operates abnormally or does not operate, and the solutions above are not useful.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This any issue, regardless of warranty terms. If you have an issue with a hOmeLabs product, please contact equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your Customer Service at homelabs.com/help or help@homelabs.com.
Page 11
For Household Use Only Distributed by hOmeLabs™, LLC 350 Springfield Avenue, Suite #200, Summit, NJ 07901 help@homelabs.com homelabs.com/help All rights reserved, hOmeLabs™ Made in China.
Need help?
Do you have a question about the HME1001 and is the answer not in the manual?
Questions and answers