Programming The System - AVIRE RATH SmartView 2 Installation & Operation Manual

Programming the System

The SmartView 2 hardware configuration settings can be programmed either locally with an Ethernet cable (not
provided), or over WIFI. Follow steps below for desired option.
WIFI:
1. Plug the WIFI Dongle into the USB2 port on the Machine Room unit. The dongle will be active for 10 minutes
after it is plugged in. After 10 minutes, the WIFI turns off for security purposes. To restore signal, remove dongle,
wait 30 seconds, then plug it back into the USB2 port.
2. On PC, Laptop, Tablet, or Smart Phone connect to WIFI network named "sv2_MR_hotspot_xxxxxx"
NOTE: Each unit has it's own unique network name. The same network will not work for every unit.
3. Open a web browser and type in http://smartviewconfig.com
NOTE: Some web browsers my attempt to automatically correct the URL. You may need to type in
http://smartviewconfig.com to navigate to the site.
Local:
1. Disconnect routed Internet connection from "ETH IN" port.
2. Wait for Internet LED on Machine Room unit to change from GREEN to RED (approximately 30 seconds).
3. Connect Laptop or PC to "ETH OUT" port on the machine room unit using an Ethernet cable.
4. Open a web browser and navigate to http://smartviewconfig.com
NOTE: WIFI on PC needs to be disabled if programming through local connection.
Programming:
1. You will be prompted to log in to the configuration portal- log in to the configuration page using the following
credentials:
Username: smartview2
NOTE: These login credentials will only work when logging into the unit for the first time.
2. For security reasons you will be prompted to update the username and password, this can be changed at a
later date if desired. Password must be at least 5 characters long and contain 1 lowercase letter, one uppercase
letter, one number, and one special character. Write down what username and password has been changed to.
NOTE: If user name or password is forgotten the device will need to be reset using the reset button on the
machine room unit. See page 12 for detailed reset instructions.
Password: password
Page 7