TP-Link TL-WR840N Quick Installation Manual

Quick Installation Guide
Multi-mode Router
Meet all your needs.
TL-WR840N
If your internet connection is through an Ethernet
cable directly from the wall, instead of through a
modem, connect the Ethernet cable to the router's
WAN port, and skip Step 1,2,3.
Confirm that the following
LEDs are on and solid to
verify the hardware
connection is correct.
Power Wi-Fi Internet
On On On
POWER WAN
Power adapter
Connect the power adapter to the
router and turn on the router.
Configure the router
1. Connect your computer to the router (Wired or Wireless)
Wired
Turn off the Wi-Fi on your computer and connect it to the router via an
Ethernet cable.
Wireless
Connect your device to the router's Wi-Fi using the SSID (Network
Name) and Wireless Password printed on the label at the bottom of
the router.
Wireless Password/PIN:XXXXXXXX
SSID:TP-LINK_XXXX
WPS/
1 2 3 4 RESET
Router
2. Configure the router using a web browser
A Launch a web browser, enter http://tplinkwifi.net
or http://192.168.0.1 in the address bar. Use
admin for both username and password, and
then click Login.
Note: If the login window does not appear, please
refer to FAQ > Q1.
B Click Next to start the Quick Setup. Select Standard Wireless Router and follow the step-by-step
instructions of the Quick Setup to complete the initial configuration.
Note: If you are not sure of the WAN Connection Type, please click Auto-Detect.
Turn off the modem, and remove the
backup battery if it has one.
Turn on the modem and then wait
about 2 minutes for it to restart.
Modem
Connect the modem to the router's WAN
port via an Ethernet cable.
http://tplinkwifi.net
admin
admin
Login