Additional Tools Needed; Step 2. Mark Position - Coolaroo Wand Operated Outdoor Roller Shade Installation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Idle End Unit
Bracket (Left)
Bracket
Cover
Bottom
Rail

ADDITIONAL TOOLS NEEDED

• Drill with 3/32 in. bit
• Phillips head screwdriver
• Tape measure
STEP 1. DETERMINE MOUNTING METHOD
Your roller shade comes ready to mount to a vertical
wall surface. If this is your preference, please go to
STEP 2. To mount your shade from the top/ceiling,
follow these steps to reset your Wand Unit Bracket and
Idle End Unit Bracket before positioning your shade.
A. Remove the two screws from both brackets (Fig. 1).
B. Turn the Wand Unit 90° so the wand eyelet hangs
straight down. Now turn the Idle End Unit 90° so
the opening is facing away from the window or the
surface (Fig. 2), then put the screws back in.

STEP 2. MARK POSITION

Identify the bracket-to-bracket distance of your shade
(Fig. 3). Mark the holes on the mounting surface for the
desired shade position.
Roller Tube
Shade
• Pencil
• Level
Bracket
Cover
End Cap
x8
Wood
Bungees and
Screws
Receivers
Wand
Fig. 1
Fig. 2
Wand Unit
Bracket (Right)
Wand
Eyelet
Remove
screws
Rotate
90°

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Wand Operated Outdoor Roller Shade and is the answer not in the manual?

Table of Contents