Baofeng UV-25 Series Owner's Manual page 35

AL-MOD
32
- Alarm Mode
STE
33 - Squelch Tail
Elimination
RP-STE - Squelch Tail
34
Elimination
RPT-RL
35 - Delay the squelch tail
of repeater
36 ROGER - Roger Beep
37 TONE-Tone-burst
38 MENU EXIT TIME
39 VOX DELAY
POWER ON MSG
40
- Power On Message
VOICEPRI - Frequency
41
hopping system
RESET
42
- Restore defaults
SITE [0]: Sounds alarm through your radio
•
speaker only
TONE[1]: Transmits a cycling tone
•
over-the-air
CODE [2]: Transmits '119' (911 in reverse)
•
followed by the ANI code over-the-air
OFF [0] | ON [1]
OFF [0] | 1 - 10
OFF [0] | 1 - 10
OFF [0] | ON [1]
1000[0]|1450[1]|1750[2]|2100[3]
5 [0] 10[1] - 60[10] in 5 second steps
(TIMEOUT-5)/5=[n]
0.5 [0] 0.6[1] -2.0[15] in 0.1 second steps
(TIMEOUT-0.1)/0.1=[n]
LOGO[0]|VOLTAGE[1]
OFF [0] | ON [1]
VFO [0] | ALL [1]
-32-
SITE: Sounds alarm through your radio speaker
•
only
TONE: Transmits a cycling tone over-the air
•
CODE: Transmits '119' (911 in reverse?)
•
followed by the ANI code over-the-air
This function is used eliminate squelch tail noise
between BaoFeng handhelds that are
communicating directly (no repeater).
Reception of a 55 Hz or 134.4 Hz tone burst
mutes the audio long enough to prevent hearing
any squelch tail noise.
This function is used eliminate squelch tail noise
when communicating through a repeater.
Delay the Tail Tone of Repeater (X100
milliseconds)
Sends an end-of-transmission tone to indicate to
other stations that the transmission has ended.
To send out a tone-burst; you simultaneously will
press a key while holding down the PTT. No
further configuration required using this feature.
The time setting for menu exit without menu
operation.
There's a brief delay between when you finish
talking and the radio returns to tx mode; this
delay can be adjusted.
Welcome message displayed immediately after
startup.
The LOGO is programmed by the manager.
Activate the frequency hopping function to
prevent interference from outside the group
Resets the radio to factory defaults, with some
exceptions.