Packaging, Transport And Storage - Vega B 61-300 FI Operating Instructions Manual

Functional principle
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
B 61-300 FI • For supply and signal cables with leakage circuit breaker
Varistors (voltage-dependent resistors) as well as overvoltage ar-
resters (gas arresters) are used as protective elements for voltage
limitation.
As soon as the voltage reaches the response voltage of the protec-
tive element increases, it becomes conductive and dissipates the
energy by briefly bridging the supply cables. When the voltage surge
subsides, the protective element returns to high-impedance status
and has no further influence on the supply circuit.
Due to this protective concept of B61-300 FI without energy dis-
sipation to ground, a connected fault-current circuit breaker is not
triggered.
3.3

Packaging, transport and storage

Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging consists of environment-friendly, recyclable card-
board. For special versions, PE foam or PE foil is also used. Dispose
of the packaging material via specialised recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
•
Dry and dust free
•
Not exposed to corrosive media
•
Protected against solar radiation
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "Technical data -
Ambient conditions"
•
Relative moisture 20 ... 85 %
3 Product description
7