Table of Contents
Advertisement
Rack Mounting
Signal Connection
When you have completed the installation, you are ready to mount the
TBX assembly in your rack. If you are using the National Instruments
TBX Rack-Mount Assembly, refer to the TBX Rack-Mount Installation
Guide for instructions. If you are not using this rack-mount assembly,
perform the following steps to mount the TBX assembly directly onto
your DIN rail.
1. Snap the TBX terminal block onto the DIN rail with a firm push.
To remove the TBX terminal block from the DIN rail, place a
flathead screwdriver into the slot above the terminal block base and
pry it from the rail.
2. Install the SCXI chassis using the appropriate chassis rack-mount
kit.
The following warnings contain important safety information concerning
the use of hazardous voltage levels with TBX-1329 terminal blocks.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the TBX-1329 AC/DC and is the answer not in the manual?
Questions and answers