Table of Contents
Advertisement
Figure 64. Removing the middle-frame assembly
Steps
After performing the pre-requisites, you are left with the middle-frame assembly.
NOTE:
The middle-frame assembly consists of the following:
● Middle frame
● Base panel
● Wireless antennas (2)
Installing the middle-frame assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the middle-frame assembly and provides a visual representation of the installation
procedure.
92
Removing and installing Field Replaceable Units (FRUs)
Advertisement
Table of Contents
