Table of Contents
Advertisement
Figure 17. Removing the stand
Steps
1. Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base.
2. Lift the stand off the display-assembly base.
Installing the stand
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
The following procedure is applicable for both Y stand and Isosceles stand.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together.
About this task
The following image indicates the location of the stand and provides a visual representation of the installation procedure.
Removing and installing Customer Replaceable Units (CRUs)
43
Advertisement
Table of Contents
