Contents 1 Important Safety Notice 2 Your Bluetooth speaker Introduction What's in the box Overview of the speaker 3 Get started Check the battery level Charge the built-in battery Turn on/off 4 Play from Bluetooth devices Connect a Bluetooth device Play from a connected Bluetooth device Disconnect a device...
Notice of with normal household waste. We strongly advise you to take your product to an official collection point or a Philips Any changes or modifications made service centre to have a professional to this device that are not expressly remove the rechargeable battery.
Correct disposal of old products and rechargeable batteries Congratulations on your purchase, and helps prevent negative consequences welcome to Philips! To fully benefit from for the environment and human health. the support that Philips offers, register your product at www.philips.com/ Caution welcome.
Overview of the speaker Check and identify the contents of your package: Quick Start Guide Portable speaker SB500 Register your product and get support at www.philips.com/support • Speaker • USB cable for charging • Printed materials • Turn the speaker on or off.
3 Get started • Turn the shoq mode on or off. • Select different LED light patterns. Always follow the instructions in this • Turn off the lighting effect. chapter in sequence. • Charge the built-in battery. Check the battery level g AUDIO IN •...
System Battery System behavior Charge the built-in battery status status Under Beep once, Note charging without charging • It takes you approximately 3.5 hours to fully indication. charge the battery. • The micro USB socket is for charging only. Under Show the •...
4 Play from Turn on/off Bluetooth devices With this speaker, you can listen to audio from Bluetooth-enabled devices and control the incoming call through Bluetooth. • To turn the speaker on, press and Connect a Bluetooth hold for over two seconds until the LEDs light up.
» Audio streams from your Bluetooth devices that can be paired (see the user manual of the device). device to the speaker. Select [Philips SB500] displayed on • To pause or resume play, press your device for pairing. If necessary, •...
5 Other Control your phone call features After Bluetooth connection, you can control an incoming call with this speaker. Button Function Listen to an external Press to answer an incoming call. device Press and hold for two seconds to reject an With this speaker, you can also listen incoming call.
Adjust volume • When you start music streaming from a connected Bluetooth device, the During music playback, press speaker switches to the Bluetooth source increase or decrease volume. automatically. • You can press and hold -/+ to increase or Turn the shoq mode on decrease volume continuously.
Acoustic 50-20000 Hz before requesting service. If the problem frequency remains unsolved, go to the Philips Web response page (www.philips.com/support). When 2 x 2” full range, 4 Ω Speaker driver you contact Philips, make sure that the Bass 2 x 2.5”...
• The Bluetooth reception is poor. Move the device closer to this product or remove any obstacle between them. Fail to fnd [Philips SB500] on your device for pairing. • Press and hold for two seconds to enter pairing mode, and then try again.
Page 15
This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.