Sealey SCS901 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear
instruction eye
manual protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
‰
WARNING! This kit contains glue. If you require a safety data sheet, contact your Sealey stockist.
‰
WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
‰
WARNING! Avoid contact with eyes, skin and vehicle bodywork.
‰
WARNING! Causes skin irritation.
‰
WARNING! Causes serious eye irritation.
‰
WARNING! May cause an allergic skin reaction.
‰
WARNING! May cause respiratory irritation.
‰
This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer's manual.
9
Ensure that the kit is correct for the task.
9
Use only outdoors or in a well-ventilated area.
9
If on skin: Wash with plenty of soap and water.
9
If in eyes: Rinse cautiously with water for several minutes: Remove contact lenses if present and easy to do. Continue rinsing.
9
Dispose of contents/ container to an approved waste disposal plant.
9
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
9
DO NOT use the kit for any purpose other than that for which it is designed.
8
Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9
Keep children, animals and unauthorised persons away from the working area.
9
DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
8
After use, store in a safe, dry childproof area.
9
NOTE: If the damage is right in front of the driver - in the area known as 'Zone A' for MOT testing - damage up to 10mm diameter will
normally result in an MOT failure. Also damage greater than 40mm in the remaining swept area will normally result in a failure. Always refer
to the latest MOT information to make sure the repair is legal. Referring to the figure below, Zone 'A' is:
1. In the swept area of the windscreen.
2. 290mm wide.
3. Centred on the centre of the steering wheel.
2. INTRODUCTION
Simple step-by-step process and a 30 minute curing time. Pressurising applicator penetrates deep inside chips and cracks to give an
almost invisible repair. Tough resin formula fills damaged area to prevent from spreading, avoiding costly windscreen replacement.
Suitable for screen chips up to Ø25mm diameter and cracks up to 300mm long. Curing process can be sped up by using a UV lamp
(not included). Improves visibility and safety.
© Jack Sealey Limited
WINDSCREEN REPAIR KIT
SCS901
MODEL NO:
Wear Warning
protective
gloves
Original Language Version
SCS901 Issue:3 (1) 27/02/24