Sealey SCR91 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
‰
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
9
Locate seat in a suitable working area.
‰
WARNING! Use seat on level and solid ground, preferably concrete.
9
Keep the seat clean and tidy in accordance with good workshop practice.
8
DO NOT use the seat for any purpose other than that for which it is designed.
8
DO NOT stand on the seat.
8
DO NOT use the seat outdoors.
8
DO NOT get the seat wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat base.
8
DO NOT use if damaged.
2. INTRODUCTION
Composite framework with concealed under seat. Suitable for use in Bodyshop and Detailing environments as well as general garage use.
Easy-rolling Ø100mm rubber castors with ball-bearing swivel. Supplied with six interchangeable cup/bottle holders and storage trays for
tools and components.
3. SPECIFICATION
Model No ....................................................................SCR91
Overall Size (W x D x H) .........................990 x 470 x 400mm
4. CONTENTS
1 Seat Cover
2 Removable Drawer (Front)
3 Drawer Holder
4 Removable Tray (Side)
5 Frame
6 Steel Nut M10 Zinc
7 Castor Wheel Support
8 Hex Head Set Screw M10 X 40 Zinc
9 Removable Tray (Cup/Bottle Holder)
10 Steel Nut M10 Domed
11 Flat Washer M10 Zinc
12 Castor Wheel
5. ASSEMBLY
5.1. Fix Castor Wheel Supports (item 7) to Frame (item 5)
using fixings (items 6 and 8).
5.2. Fit Castors (item 12) to Castor Wheel Supports (item7) using nuts and washers (items 10 and 11).
5.3. Locate remaining items into body as shown in fig.1.
6. MAINTENANCE
6.1. Before each use, inspect the overall condition of the unit for broken, cracked or bent parts that may affect the proper operation.
6.2. Regularly check the tightness of all fixings before use.
6.3. Smear the castor bearings with a thin film of silicone grease quarterly.
6.4. Ensure the castor wheels are able to rotate and swivel freely. Replace if necessary.
6.5. Clean the seat cushion, trays and frames with a moist cloth and mild detergent. DO NOT use solvents to clean the unit.
© Jack Sealey Limited
MECHANIC'S DETAILING UTILITY SEAT
SCR91
MODEL NO:
Fig.1
Original Language Version
SCR91 Issue 1 31/05/22