Advertisement
EB
WIPE MODE
DIGITAL EFFECT
OOO
STROBE
i
~
stm
MOSAIC]
| PANT
MIX WIPE EFFECT/FADE CONTROL
PaNPr
mx
EOGE
AUDIO FOLLOW
Normal
Negative
E. Auto Take
i Negative
7 Press the NEGA button.
A negative picture is obtained.
Notes:
1. Still and Strobe modes cannot be selected at the
same time on the same bus.
2. If picture size is changed by operating the P-IN-
P/EDGE button, Still or Strobe mode of the res-
pective buses will be released. This occurs when
the MIX or WIPE/EDGE button is pressed after the
P-IN-P/EDGE
button, or when the P-IN-P/EDGE
button is pressed after the WIPE/EDGE
or MIX
button,
Instead of the slide controlled Mix and Wipe using the Mix/Wipe Control, automatic Mix and Wipe operation can be performed
using the Auto Take function.
MIX WIPE EFFECT/FADE CONTROL
vapey
Ne
| j Amoroucw
JEJE)
ED
-29-
Reset the operation panel to initial mode.
1 Set a transition time by adjusting the
TIME control.
Transition time can be adjusted from 0 to 10.2 sec.
approximately.
2 Press the AUTO TAKE button.
The LED lights. After Auto Take, the LED goes out.
Notes:
1. If you press the button before Auto Take is com-
pleted, it stops and the LED starts blinking. If you
want to start it again, press the button again.
2. To release Auto Take mode, slide the Mix/Wipe
Control fully to either the A-bus or B-bus position.
Advertisement
