Advertisement
ADVANCED OPERATIONS
A. Colour Correction
This function allows colour adjustment of a selected input source, as well as compensation for excessive colour.
Notes:
1. The Chroma Level Control (CHROMA) will have no effect if the selected source video is a black/white picture.
2. The same colour correction should be made on both the A-bus and B-bus pictures.
Reset the operation panel to initial mode.
@ To correct the colour of the A-bus picture
mmrosmonco..
\ 1,
mam
o
—@
MIX WIPE EFFECT/FADE CONTROL
1 Slide the Mix/Wipe Control to the A-bus
position.
2 Press one of the A-bus Selection
Buttons.
3 Press one of the B-bus Selection
Buttons.
4 Press the SELECT button.
The LED on the COL.CORRECT position should light.
5 Press the A button once.
The LED starts blinking.
Mix WIPE EFFECT/FADE CONTROL
6 Adjust the CHROMA Control.
The colour level can be changed.
7 Press the A button again.
The LED lights steadily.
8 Adjust the CHROMA Control and
operate the Joystick Control.
The colour level (CHROMA) and colour phase (R/G/B)
can be adjusted.
9 Press the A button a third time.
The
LED
goes
out and
Colour
Correction
can
be
released.
Note: Position A of the picture is stored in the memory
while colour correction is under way. Refer to B.
Position Control below.
-23-
Advertisement
