Sealey WC06.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction
gloves
manual
1. SAFETY
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that may
‰
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by
the operator. It is the operators responsibility to secure the load. Check with vehicle manufacturer's Manual before installing.
Make sure the wheel of the equipment being mounted or dismounted is aligned with the chock.
9
Inspect chock before each use. Check fasteners for tightness, replace any worn or damaged parts.
9
DO NOT attempt to use a chock that is damaged in any way.
8
DO NOT modify the chock in any way.
8
Proper care and maintenance of the chock is critical to safety.
9
Proper use of this product is critical to safety. Improper use may result in personal or property damage which is not covered by the
9
warranty.
2. INTRODUCTION
Wheel chock supports the wheel of the motorcycle when in transit or storage. Made from black powder coated heavy-duty tubular steel
with pre-drilled holes and fixings which allow chock to be fixed to any suitable surface. A range of three sizes is available covering
maximum tyre widths of 95mm, 140mm, and 165mm.
3. SPECIFICATION
MODEL NO.
Maximum Tyre Width
4. CONTENTS
© Jack Sealey Limited
MOTORCYCLE WHEEL CHOCKS
MODEL NO'S:
WC06.V2 WC07.V2
95mm 140mm
Original Language Version
WC06.V2, WC07.V2, WC08.V2
WC08.V2
165mm
WC06.V2, WC07.V2, WC08.V2 Issue 1 22/01/24