Sealey WCT02 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear
instruction protective
manual gloves
1. SAFETY
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator. It is the operator's responsibility to secure the load. Check with vehicle manufacturer's Manual before installing.
WARNING! Before use, ensure that there is nothing attached to the front forks or the fairing of the motorcycle, that will foul on the chock.
‰
Proper use and installation of this product is critical to safety. Improper use may result in personal or property damage which is not
9
covered by the warranty.
Proper care and maintenance of the chock is critical to safety.
9
Keep the chock clean for the best and safest performance.
9
Maintain correct balance and footing whilst positioning the motorcycle in the chock.
9
Ensure that the floor is not slippery and wear non-slip shoes.
9
Ensure that the motorcycle is adequately secured to the chock if to be used for transportation purposes. Consideration should also be
9
given to securing the rear wheel as well.
Keep children and unauthorised persons away from work area.
9
Inspect chock before each use. Check fasteners for tightness, replace any worn or damaged parts.
9
Before removing a motorcycle from the chock, ensure that there are no obstructions or persons in the path of the motorcycle.
9
DO NOT attempt to use a chock that is damaged in any way.
8
DO NOT modify the chock in any way.
8
DO NOT use the chock for a purpose it is not designed to perform.
8
DO NOT operate the chock if it is damaged.
8
DO NOT use the chock when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow untrained persons to use the chock.
8
2. INTRODUCTION
i
Black powder coated heavy-duty tubular frame. Pre-drilled holes allow chock to be bolted to the floor of a vehicle or trailer bed to prevent
movement and maintain balance. Suitable for motorcycles with up to 170mm wide tyres.
3. SPECIFICATION
i
Model No.: ................................................................. WCT02
Minimum/Maximum Tyre Width ............................. 50/170mm
© Jack Sealey Limited
INSTRUCTIONS FOR
MOTORCYCLE FRONT WHEEL CHOCK
MODEL NO:
Wear
protective
footwear
Original Language Version
WCT02
WCT02 Issue 1 06/03/18