Table of Contents
Advertisement
Spectrum display
This shows the level of each sound range (frequency range).
The following 6 types of display modes are possible.
Each time the spectrum mode-select demonstration button is
pressed, the display mode changes.
1. Peak-hold display
The peak sound value of each sound
range is held on the display for about
one second after it occurs.
2. Dot display
Only the upper two parts of the bar
display are shown, thus maidng the
strength of the sound for each sound
range even easier to see.
3. Hustler mods
The peak sound value of each sound
range is displayed in augmented
form.
4. Aurora mode
The peak sound value of each sound
range is displayed in Inverted form.
5. Afterimage display
After indicating the peak sound value
of each sound range, it will fall down
giving an afterimage.
6. Repeat mode
Indicates each of 1 to 5 sequentially
for about five seconds at a time.
To temporarily reduce the volume level
I MUTING I
Press Wie muting button on the remote control transmitter. The
volume level is attenuated by 20 dB (approx. 1/10).
if the audio output has been muted by the muting button on the
remote control transmitter (the muting indicator is lit), the muted
state can be cancelled by pressing the muting button once again or
by setting the volume level to the "— dB" position.
-
21
-
Advertisement
Table of Contents
