Kenwood KT-5020 Instruction Manual page 5

Caution: Read this page carefully to ensure safe oper¬
ation.
12. Carts and stands-An appliance and cart combina¬
tion should be moved with care. Quick stops, exces¬
sive force, and uneven surfaces may cause the appli¬
ance and cart combination to overturn.
13. Nonuse periods - The power cord of the unit should
be unplugged from the outlet when left unused for a
long period of time.
14. Abnormal smell - If an abnormal smell or smoke is
detected, immediately turn the power OFF and pull
out the power cord. Contact your dealer or nearest
service center.
POWER OFF!
15. Damage requiring service-The unit should be
serviced by qualified service personnel when:
A. The power-supply cord or the plug has been
damaged: or
B. Objects have fallen, or liquid has been spilled into
the unit; or
C. The unit has been exposed to rain; or
D. The unit does not appear to operate normally or
exhibits a marked change in performance; or
E. The unit has been dropped, or the enclosure
damaged.
16. Servicing-The user should not attempt to service
the unit beyond that described in the operating
instructions. All other servicing should be referred to
qualified service personnel.
17. Outdoor antenna grounding - If an outside antenna
is connected to the receiver, be sure the antenna
system is grounded so as to provide some protection
against voltage surges and built up static charges.
Section 810 of the National Electrical Code, ANSI/-
NFPA No. 70-1984, provides information with re¬
spect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna-discharge unit connection to grounding
electrodes, and requirements for the grounding elec¬
trode. See Figure.
3 Use No. 10 AWG (5.3 mm2) copper, No.8 AWG (8.4 mm2)
aluminum. No. 17 AWG (1,0 mm2) copper-clad steel or bronze
wire, or larger, as a ground wire,
b Secure antenna lead-in and ground wires to house with stand- off
insulators spaced from 4-6 feet (1.22 - 1.83 m) apart.
c Mount antenna discharge unit as close as possible to where lead-in
enters house.
d
Use jumper wire not smaller than No.6 AWG (13.3 mm2) copper,
or the equivalent, when a separate antenna-grounding electrode is
used. See NEC Section 810-21(j).
18. Power lines - An outdoor antenna should be located
away from power lines.
19. AC outlets-Do not connect other audio equipment
with a power consumption larger than that specified
to the AC outlet on the rear panel. Never connect
other electrical units, such as an iron or toaster, to it
to prevent fire or electric shock.
Notes: -
1. Item 3 is not required except for grounded or polarized equipment.
2. Item 17 and 18 are not required except for units provided with antenna terminals.
3. Item 17 complies with UL-1270 in the U.S.A.
4. Item 19 is not required except for units provided with AC outlets.
KT-5020 (En)
5