Protecting The Environment; Rechargeable Battery Pack - DeWalt DCN660NT Original Instructions Manual

ENglish
cycled to reset the electronic control. These requirements
are indicated by the tool, using the worklights.
Worklights are on, motor runs, tool does not drive
fasteners fully.
Adjust the driving depth (See Adjusting the Driving Depth
•
section of this manual).
• Change tool to seq mode if not already in seq mode.
• Choose the appropriate fastener length \ material.
Check battery power level (See Fuel Gauge Battery Packs
•
and Low Battery Indicator section of this manual).
• Clean the nosepiece with compressed air. Do not
use lubricants.
• Clean the magazine with compressed air.
• Driver blade assembly may be damaged\worn. Please
contact your repair agent if above steps do not resolve
the issue.
NOTE: The stall release lever should be used to reset the
mechanism. The Trigger Lock Off may also need to be
cycled to reset the electronic control. These requirements
are indicated by the tool, using the worklights.
Fasteners jam in tool.
Check that correct type of fasteners are loaded in to the
magazine properly and that the pusher is pushing the fastener.
• Choose the appropriate fastener length \ material.
Clean the nosepiece (See Clearing a Stall or Jammed Nail
•
section of this manual).
• Clean the magazine with compressed air.
• Driver blade assembly may be damaged\worn. Please
contact your repair agent if above steps do not resolve
the issue.
NOTE: The stall release lever should be used to reset the
mechanism. The Trigger Lock Off may also need to be
cycled to reset the electronic control. These requirements
are indicated by the tool, using the worklights.

Protecting the Environment

Separate collection. Products and batteries marked
w
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that
can be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
14