JVC GR-SXM915 Instructions Manual page 50

Display
Power Switch
Button
R/M Button
Jg
indicator
Counter
Remote sensor
insert @ifing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V705U remote control unit to perform this
procedure.
SELECTOPERATION MODE
Set the Power Switch to "PLAY".
FEND EDIT-OUT POINT
Play back the tape, locate time point and press PAUSE
on the camcorder or the remote control.
RESETCOUNTER
Press and hoH COUNTER R/M for more than
second to reset time tape counter, then press again
for less than 1 second so that "M" appears.
FIND EDIT4N POINT
Press REW to go a little beyond time beginning of time
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the
point where the new scene should start.
ENGAGE iNSERT EDITING MODE
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. Time Insert Editing
standby mode is engaged. Time Insert Editing Indicator
is displayed on time top left corner of time LCD monitor
or viewfinder. When time scene the camcorder is
aimed at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches
"0:00:00", editing stops automatically and the
camcorder enters the Insert-Pause mode.
END iNSERT EDiTiNG
Press STOP.
START/STOP
PLAY
STOP
PAUSE
REW
INSERT
RM-V705U
(provided)
NOTES:
• During Insert Editing, the original audio will be heard
from the speaker:
• After step 5, Retake (_,z_ pg. 23) can be performed.
• The tape may stop slightly before or after the designated
end point, and noise bars may appea_ Neither indicates
a defect in the unit.
• Only the video signal is recorded in the Insert Editing
mode.