Advertisement
Available languages
Available languages
AVD
Disconnecting TV Cable
Disconnect
the antenna
cable from
the back of your TV set.
f
TV back panel
© ANTENNA IN
Connected to outdoor
or indoor antenna or cable
Connecting Antenna Cable to VCR
Connect
the antenna
cable
to the
ANTENNA IN terminal of your VCR.
ANTENNA
IN
VCR rear
Connecting VCR to TV
Connect the supplied coaxial cable
to the RF OUT terminal of the VCR.
Plug the other end into your TV's
ANTENNA IN terminal.
ANTENNA IN
Rear of the VCR
CTESTSi
TEST SIG ON/OFF switch
RF Convertor Output Channel adjustor (CH30 ~ CH39)
To view the output of your VCR on the television screen, you must select an
unused channel on your TV and tune it to the output of your VCR (factory
preset to UHF channel 36).
@ Select the AV or an unused channel on your TV
au press the OPERATE button on the VCR to
@ Set the SYSTEM switch according to your TV
set. If the broadcast system of the TV channel
you are watching is not known, refer to SET-
TING THE SYSTEM SWITCH (PLAYBACK and
RECORDING), page 10.
© Set the TEST SIG switch to ON.
@ Adjust the tuning of the selected TV channel
until the test pattern (two vertical bars) appears
on the screen.
© Set the TEST SIG switch to OFF.
NOTE:
If interference or a beat pattern is received when
the test pattern is tuned in, use a small screwdriver
to turn the RF Convertor Output Channel adjustor
to change the VCR output channel and then retune
your TV as above.
Advertisement
