Troubleshooting - Husqvarna LC 251i Operator's Manual

7. Lock the blade with a piece of wood. Attach the
washers and tighten the bolt with a torque of 23 –
28 Nm.
Battery
LED on the battery
The green LED flashes.
The battery error LED
flashes.
The battery error LED
comes on.
18

Troubleshooting

Cause
The battery voltage is
low.
The battery is too cold
or too hot to use.
The battery is empty.
There is a permanent
battery error.
8. Pull the blade around by hand and make sure that it
turns freely.
WARNING:
The blade is very sharp and cuts can
easily occur.
9. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
To do a check of the side discharge
deflector
The side discharge deflector is attached to the side
discharge opening of the product. It decreases the risk
of objects to eject in the direction of the mow position of
the operator.
1. Make sure that the side discharge deflector is not
damaged.
2. Examine the side discharge deflector. Make sure
that you do not see defects, such as cracks or
broken springs that push the door to close.
3. Replace the side discharge deflector or the springs if
they are damaged.
Solution
Charge the battery. Refer to
Let the battery cool down or move it indoors to warm it up.
When the battery has the correct temperature, it can be used
again. Use the battery in the product only when the ambient
temperature is 5 °C–40 °C.
Charge the battery. Refer to
Speak to your Husqvarna servicing dealer.
Use heavy duty gloves.
To charge the battery on page 12 .
To charge the battery on page 12 .
2207 - 003 - 26.10.2023