Function Selector; Signal Meter; Tuning Meter - Yamaha CT-600 Owner's Manual

tuning}. Then, when you remove your hand the
AFC goes on and the lamp lights (AFC locks on
to the station for drift-free reception) If the
signal is very weak, however, the lamp may fail
to light.
@ POWER SWITCH
Use it to switch on the CT-600.
@ OUTPUT LEVEL CONTROL
Adjusts the level of output signal strength. Af-
fects only the signals passing through connector
cords plugged into the Variable jacks on the rear
panel. This control is ideal for matching the
CT-600 output to those of other units, such as
a tape deck, record player, etc.
@ MUTING SWITCH
This switch turns on the muting circuit which
cancels noise between FM stations while tuning
(see p. 19).
@ HIGH BLEND SWITCH
With this switch on, high-frequency noise will be
cut from FM stereo signals. If there is no noise
problem, leave this switch off.
@ FUNCTION SELECTOR
This switch lets you select AM or FM reception.
РМ Mono:
Set to this position only when you
are receiving an FM stereo signal
which contains
an intolerable
a-
mount of noise. The noise will be
cut somewhat, although the stereo
effect will be lost.
@ SIGNAL METER
to the right, the stronger the signal.
@ TUNING METER
Tune for exact needle centering.
® TUNING KNOB
13