Honeywell VIP7201 Setup Manual page 13

11. Reset the CONFIGuration bit:
a. Press SET UP key.
b. Use
G
key to position
cursor.
c. Use
[!]
key to change bit
setting,
d. Change the CONFIGuration
line to appear as shown in
diagram.
CONFIGHH]
IDE ffi1J ffi8
~
ffi8
Em)
fH8
~ BAUD=300
1 ' 2 3 4 5 6 7 8 9
12. Press SET UP key. CONFIGuration
line disappears.
NOTE
CONFIGuration line char-
acteristics deserve careful
study, see Section 3 for
details.
13. Three keys remain untested:
• The BREAK Key
• The Blank key to the left of
the BREAK key
• The Blank key to the right of
the F7 key.
Until your terminal is connected to
its Host, you must test these keys
by listening to the key click rates.
If a key does not click, or clicks at
the wrong rate, see the HELP card.
Press and hold down any alpha-
betic key and hear the normal key
click rate. Use this rate as reference
for the following tests: .
a. Press and hold down a SHIFT
key and the BREAK key and
hear a key click rate of about
5 times per second (i.e., slower
than normal).
b. Press and hold down the Blank
key to the left of the BREAK
key and hear the normal key
click rate.
c. Press and hold down the Blank
key to the right of the F7 key
and hear the normal key click
rate.
2-6
14. Press top push button to turn OFF
power.
NOTE
After turning power OFF,
wait 10 seconds before turn-
ing power ON again; this
ensures complete reset of tqe
terminal's electronics.
15. After installing communications
cable, connect terminal end to
MAIN port.
NOTE
Wiring and connection of
the terminal end connector is
a Customer responsibility.
/
-====;::,1.
For a fuller understanding of your
terminal's functions, read Section 3 and
Section 4. After reading those sections,
SA VE THIS MANUAL AND ALL
TERMINAL PACKAGING (in case termi-
nallater requires repairs).
CP91-00