STIEBEL ELTRON CNS-U 500 Plus LCD Operation And Installation Manual

STIEBEL ELTRON CNS-U 500 Plus LCD Operation And Installation Manual

Wall mounted convector

Advertisement

Quick Links

Operation and installation
CNS-U 500 Plus LCD (UK) /
CNS-U 750 Plus LCD (UK) /
CNS-U 1000 Plus LCD (UK) /
CNS-U 1500 Plus LCD (UK) /
CNS-U 2000 Plus LCD (UK) /
CNS-U 2500 Plus LCD (UK) /
CNS-U 3000 Plus LCD (UK)
Wall mounted convector
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CNS-U 500 Plus LCD and is the answer not in the manual?

Questions and answers

Summary of Contents for STIEBEL ELTRON CNS-U 500 Plus LCD

  • Page 1 Operation and installation CNS-U 500 Plus LCD (UK) / CNS-U 750 Plus LCD (UK) / CNS-U 1000 Plus LCD (UK) / CNS-U 1500 Plus LCD (UK) / CNS-U 2000 Plus LCD (UK) / CNS-U 2500 Plus LCD (UK) / CNS-U 3000 Plus LCD (UK) Wall mounted convector...
  • Page 2: Table Of Contents

    Table of contents 1 Special information ........... 3 2 General information..........3 Symbols in this document ........ 3 Symbols on the appliance......... 3 Units of measurement ........3 3 Safety................ 3 Structure of the warning notices....... 3 Intended use ............ 4 Foreseeable misuse..........
  • Page 3: Special Information

    Special information Special information General information – Keep children under the age of 3 away from Read these instructions carefully before using the the appliance if constant supervision cannot appliance and retain them for future reference. be guaranteed. Pass on these instructions along with the appliance as necessary.
  • Page 4: Intended Use

    Appliance description Property damage, consequential losses, environmental any risks that may result. This is subject to the appliance pollution having been installed as described. Children from the age of 3 to 8 must not regulate the appliance. NOTICE – This appliance may be used by people (including children) Type and source of risk with reduced physical, sensory or mental capabilities or a Consequence(s) of failure to observe the warning no-...
  • Page 5: Standard Delivery

    Installation (qualified contractors) The air inside the appliance is heated by a heating element and expelled via natural convection through the air discharge at the top. Cool indoor air is drawn in through the air intake on the underside of the appliance. When the set room temperature is reached, it is maintained by periodic heating.
  • Page 6: Electrical Connection

    Commissioning (qualified contractors) Temperature setback via control cable To reduce the temperature to the set setback temperature, the black control cable is activated via an external electronic contact (e.g. a time switch). Connection of control cable to an external control unit The appliance can be connected to any control unit that issues control signals with any of the following waveforms.
  • Page 7: Programming Unit

    Settings All settings remain intact after switching off or after an interrup- Sym- Description tion to the power supply. A power reserve in the appliance en- bols Adaptive start: sures that the day of the week and the time are saved for several hours.
  • Page 8: Standard Menu

    Settings The default display is displayed continuously. If no user input is Calling up actual values, programming time programs and made for more than 20  seconds while in the menu, the device setting parameters automatically returns the default display. u To call up the configuration menu, press and hold the but- The default display shows the current set room temperature as ton.
  • Page 9: Cleaning (Users)

    Cleaning (users) To configure comfort phases in time programs Pro1 and Pro2: P1: Room temperature offset Uneven temperature distribution in the room can result in a dif- u In the configuration menu, call up the required time pro- gram using "+" and "–". ferential between the displayed actual temperature ...
  • Page 10: Troubleshooting (Qualified Contractors)

    Troubleshooting (qualified contractors) Fault Possible cause Remedy Fault Possible cause Remedy The room gets too Appliance temperat- Check the selected Appliance is in "FP" When the appliance Check external con- hot. ure is set too high. room temperature. program but does does not detect a trol unit and its set- Adjust if necessary.
  • Page 11: Energy Consumption Data

    Specification 13.2 Energy consumption data Product information on electric local space heaters to regulation (EU) 2015/1188 The product data complies with EU regulations relating to the directive on the ecodesign of energy related products (ErP). CNS-U CNS-U CNS-U CNS-U CNS-U CNS-U CNS-U 1000...
  • Page 12: Guarantee

    Guarantee CNS-U CNS-U CNS-U CNS-U CNS-U CNS-U CNS-U 1000 1500 2000 2500 3000 Plus Plus Plus Plus Plus Plus Plus (UK) (UK) (UK) (UK) (UK) (UK) (UK) Protection class Colour alpine alpine alpine alpine alpine alpine alpine white white white white white white...
  • Page 13 www.stiebel-eltron.com CNS-U 500-3000 Plus LCD (UK) |...
  • Page 14 | CNS-U 500-3000 Plus LCD (UK) www.stiebel-eltron.com...
  • Page 15 www.stiebel-eltron.com CNS-U 500-3000 Plus LCD (UK) |...
  • Page 16 Comfort through Technology STIEBEL ELTRON International GmbH Dr.-Stiebel-Straße 33 / 37603 Holzminden / Germany info@stiebel-eltron.com / www.stiebel-eltron.com 4 0 1 7 2 1 3 5 6 4 3 9 3...

Table of Contents