42
4. Remove the lid from the beans container. Empty out the container,
transferring any remaining beans to another recipient;
5. Wipe the inside and the outside of the container clean with a soft
moist cloth, removing all residual traces of coffee.
6. Clean the socket in which the beans container is held on the ma-
chine, using the brush and a soft moist cloth. Remove powdery
coffee residues with a vacuum cleaner.
7. Dry the beans container and the lid thoroughly, using a clean dry
cloth or absorbent paper: make certain all the surfaces are com-
pletely dry.
8. Fill the container with coffee beans and close with the lid. To carry
out the operation correctly, align the unlock symbol
notch on the adjuster ring (fig. 40) and, when inserted, twist the
beans container into the locked position
Coffee grounds container
When required by the machine, this must be emptied and cleaned. The
machine cannot be used to make coffee until the grounds container has
been cleaned. The machine will display the message indicating the need
to empty the grounds container 72 hours after the first coffee has been
prepared, even if the container is not full (for the 72 hours to be calculated
correctly, the machine must never be disconnected from the mains power
supply).
Important! Danger of scalding
If several milk-based drinks are prepared one after the other, the metal
cup tray becomes hot. Wait for it to cool down before touching it and
handle it from the front only.
To clean (with the machine on):
1. Remove the drip tray and coffee grounds container;
2. Empty the drip tray and the grounds container and clean them thor-
oughly to remove all residues that may have collected on the bottom.
3. Reposition the drip tray in the machine, complete with grille and
grounds container.
Important!
When removing the drip tray, the grounds container must be emptied,
even if it contains few grounds. If this is not done, it can happen that
when further coffees are prepared, the grounds container will fill up
more than expected and clog the machine.
Drip tray and drip tray grille
The drip tray is fitted with a float level indicator (colour red) showing the
amount of water it contains (fig. 42).
33
with the
(fig. 41).
Need help?
Do you have a question about the RIVELIA and is the answer not in the manual?
Questions and answers
Как снять варочный блок для чистки
To remove the brewing unit for cleaning on the DeLonghi Rivelia:
1. Ensure the machine is completely turned off and unplugged.
2. Pull out the water tank and remove the lid.
3. Squeeze the red levers of the brewing unit inward while pulling it out.
4. Rinse off any coffee pulp gently.
5. Submerge the unit in water for 5 minutes (do not use any cleaning solution).
6. Take it out, wipe it dry with a paper towel, and avoid touching the metal filter.
7. Clean the cavity before reinserting the unit.
8. Reinsert the unit until it snaps into place.
9. Clean and reattach the lid, then put the water tank back.
The brewing unit should be cleaned every month.
This answer is automatically generated
I have muddled up my coffee settings sometimes it can’t complete as it’s too strong where can I find the factory settings? It a rivella
I wish to get a printed book Copy of the Manual
Is there any way of turning on illumination on the ON/OFF switch?
The coffee delivery is very slow and water is collecting in the grounds tray and not into cup.