Table of Contents
Advertisement
Fold back both locking levers (figure C). Close the oven
3.
door.
&
ã=
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the aftersales service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
and zeros
0
light up in the
display.
The oven does
There is dust on
not heat up.
the contacts.
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
&
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Insert the panel diagonally towards the back (fig. A).
1.
Stick the retaining clips onto the right and left-hand sides of
2.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
$
Insert the uppermost panel diagonally towards the back. The
3.
smooth surface must face outwards.
Put the cover back in place and screw it on.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly fitted.
Error messages
If an error message with
"
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
%
appears, press the
button. The
0
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
13
Advertisement
Table of Contents
