GE 600 Series Owner's Manual page 27

Interior Surfaces (Cont.)
Air Fry Basket (on some models)
The air fry basket can be washed with warm, soapy
water or it may be cleaned in the dishwasher.
EasyWash Oven Tray
Never use the oven without the EasyWash oven tray in
place.
To avoid thermal shock and enamel cracking, allow the
EasyWash oven tray to cool before immersing in cold
water.
We recommend to wipe any loose or large debris from
the EasyWash oven tray before removing from the
oven to avoid spilling any debris on the area below the
EasyWash oven tray.
Take care not to drop or knock the EasyWash oven tray
against hard surfaces. It can damage the enamel and is
not covered by the product warranty.
Parts that are visible when the EasyWash oven tray is
removed will show discoloration due to heat. This does
not require servicing or cleaning. Do not attempt to clean
these components. This is expected with normal use,
does not affect the performance of the unit and may
change over time.
Handwashing the EasyWash oven tray is recommended
to preserve the original appearance. For tough stains,
soak the EasyWash oven tray in warm soapy water for
30 minutes before washing. Do not use harsh abrasive
cleaners. Soft nylon scrub brushes, pads or scrapers
are recommended. For more stubborn stains, a cleaner
Cleanser, can be used. Be sure to thoroughly rinse off any
excess cleaners. Failure to do so can cause changes in
the surface appearance or damage the coating.
The EasyWash oven tray can be placed in the
dishwasher, dirty side facing down and across the
bottom rack as shown below. However, dishwasher
detergents which are strongly alkaline and cycle
selection may have an impact on the appearance of
the EasyWash tray over time. This will not impair the
performance of the oven.
Make sure the EasyWash oven tray is fully dried before
placing back in the oven.
49-2001193 Rev. 0
Do not use steel wool to clean the air fry basket since
this may cause the stainless steel to rust.
Orient the EasyWash oven tray in the product so that
the writing on the integrated handle is facing forward
towards the front of the product. Not orienting the
EasyWash oven tray correctly when reinstalling could
result in uneven oven heating and poor oven cooking
performance.
TM Soft
The rear edge of the EasyWash oven tray should be
pushed back into the slot of the rear bottom trim and the
front edge of the tray should be inset in the oven cavity
and set flush with the oven cavity front edge, not on top
of it. The EasyWash oven tray should set level and not
sloped backwards
CORRECT placement.
Handle is facing forward.
CORRECT placement.
INCORRECT placement:
Tray should not be on top
of oven cavity front edge
27