Philips HTD3500 Service Manual page 20

1. There are 2 ways to software upgrade:
First :
Upgrade from USB:
Coppy the upgrade file HTD3500_XX.BIN to USB then press the USB
key on RC or SOURCE key on front panel.
When upgrade file detected, select "Yes" to upgrade, select "No" to
cancel.
After upgrading begins, a message "DO NOT POWER OFF" will show,
or the product will hang up and upgrading failed.
After you cancel, the product would not read the USB unless
upgrade file deleted.
Second:
Upgrade from Disc:
Copy the upgrade file HTD3500_XX.BIN to disc then read the disc.
When upgrade file detected, select "Yes" to upgrade, select "No" to
cancel.
After upgrading begins, a message "DO NOT POWER OFF" will show ,
or the product will hang up and upgrading failed.
After you cancel, the product would not read Disc unless upgrade file
deleted.
2. Check the version information after upgraded.
Press the setup key on RC , select Preference Setup, and then
Version info , press OK Key you will see a interface below:
3. Reset Steps:
Press"SETUP" button on RC-->Select"Redef" shows in screen-->Press"OK" on RC to confirm
Preference Setup
Version Info
-----------------------------------------------
Upgrade file Name
Version
Sub-Ver
Servo
RISC
HDCP Key
Region Code
8032
-----------------------------------------------
Press SETUP to exit menu
4-1
Software Upgrade
HTD3500_12.BIN
12.12.07.08
00.08.A0.48
57.1A.01.C7
35.31.01.3A
Pass
2
00.01.00.01