Opening And Closing The Door; Door Lock; Comfort Door Lock - Miele PFD 408 Operating Instructions Manual

Commercial dishwasher
Table of Contents

Advertisement

Door lock

Depending on the model, the dishwashers
are equipped with a Comfort Door Lock with
electronic door lock or a pull-open lock.
Dishwashers with a Comfort Door Lock
have a  door button on the control panel.
This button is not available on machines
with a pull-open lock.

Comfort Door Lock

The door of the wash cabinet is equipped
with a Comfort Door Locking Mechanism.
When the door is closed, the Comfort Door
Locking Mechanism automatically pulls the
door into the closed position and thus en-
sures it is sealed. The door is locked elec-
tronically.
For opening the door
A door that has been locked electronically
can be opened under the following circum-
stances:
- The machine is connected to the power
supply and switched on (the  LED is lit
up).
- The  LED is lit.
Press the  button to open the door.
If the temperature in the wash cabinet ex-
ceeds 153°F (67°C), a message is shown on
Hot wash cabinet: Risk of injury,
the display:
take care when opening the door.
Press the  button again to open the door.
The Comfort Door Lock opens the door
slightly. The LED in the button goes out as
soon as the door is unlocked.
The control panel of the machine is also a
door handle.
Grasp the handle underneath the control
panel and lower the door to open it.

Opening and closing the door

Close the door.
Make sure that no objects or wash items
protrude into the closing area of the door.
 Risk of injury caused by crushing.
Do not put your hand inside the door as it
is closing. Risk of crushing.
Raise the door upward until the catch en-
gages.
The door will be drawn into its final close
position if the AutoClose function is acti-
vated (see "AutoClose").
Opening the door using the emergency re-
lease
The emergency release may only be used
when it is no longer possible to open the
door normally, e.g., in the event of a power
failure.
 Danger of scalding, burning, and
chemical burns!
If the emergency release is operated dur-
ing a program sequence, hot water and
process chemicals can escape.
Only open the door using the emergency
release when strictly necessary.
The emergency release mechanism is lo-
cated on the right beside the door lock in
the gap between the door and the lid of the
machine or the countertop.
.
There should be 3/8" (1 cm) between the
right edge of the tool and the right edge of
the display.
Press against the door to release the
emergency release mechanism.
25

Advertisement

Table of Contents
loading

Table of Contents