Table of Contents
Advertisement
Adjustable toe-kick panel
(depending on the model)
Dishwashers with internal dispensing or ac-
tive drying have an adjustable toe-kick
panel.
Level the dishwasher.
Open the dishwasher door halfway and
loosen the two screws now visible at the
top of the toe-kick panel.
Pull the toe-kick panel upward first and
then forward.
Loosen the two screws on the right and
left of the toe-kick behind the panel.
Pull the inside of the toe-kick down to the
floor.
Tighten the two screws again.
Reassemble the toe-kick panel by follow-
ing the instructions above, but in reverse
order.
Removing the machine lid
If the dishwasher is installed with a lid, it
can be removed as follows:
Remove both securing screws on the
back of the dishwasher with a screwdriver.
Open the door.
Unscrew the left and right fastening
screws with a screwdriver.
Lift the machine lid upward to remove.
Leveling and securing the dish-
washer
To guarantee stability, the dishwasher must
be secured to the countertop after leveling.
After leveling, secure the dishwasher to
the continuous countertop.
With the door open, screw into the coun-
tertop through the holes in the front trim
on the left- and right-hand sides of the
dishwasher.
With stainless steel or stone countertops,
the dishwasher must be secured at the
sides to the left and right adjacent cabinetry
with two screws on each side.
Special screws (4 x 27/Torx T20) are sup-
plied in the accessories companion pack.
Holes must be drilled in the side wall in front
of the door seal for these.
In the case of undercounter dishwashers,
the holes are already provided in the side
walls.
Installation
101
Advertisement
Table of Contents
