Husqvarna PG 400 Operator's Manual page 10

1. Loosen the lock knobs (A) and adjust the handle (B)
to idle position.
A
B
2. Tighten the lock knobs to set the position.
3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B
10
A
A
B
Handle heights
Hole position Handle height, mm/in.
Top 835/33
Center 925/36
Lower 1000/39
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
1. Disconnect the motor cable (A) from the electrical
enclosure.
A
2258 - 002 - 25.10.2023