Page 1
In no event shall ABB Spa be liable for direct, indirect, special, incidental or consequential damages of any nature or kind arising from the use of this document, nor shall ABB Spa be liable for incidental or consequential damages arising from use of any software or hardware described in this document.
Page 2
Safety warning The device must always be protected on the incoming side by fuse or circuit breaker with a max nominal current of 16A 1. Mounting Instruction TL1 + TLs (peripherical device) Tightening torque Important notice After installation the cable coming out from the device must be fixed re- liably.
Page 3
Technical data TL1 Pole Rated supply voltage 110 ÷ 230 AC Contact type 1NO polarized Incandescent lamps 110 V 1000 230V 1000 LED/CFL – externally ballasted 110 V 230V LEDi/CFLi – self ballasted 110 V 230V Rated frequency 50/60 Switching delay ON 23+-10% 25+-10% Switching delay OFF...
Page 4
TL1 Pole Max terminal cross section Terminals loss-proof screw Screw Type Tightening torque: terminals Tightening torque: screw sensor Mounting on DIN Rail Pole/wall mounted Switching status indication /brightness range red/green LEDs Max wiring length Max wiring width 1000w all other sensor 0,75 Modules...