Sharp FLASH PATH VR-1FPN Operation Manual page 6

Important Information
Precautions
ə The FlashPath is an adapter for using SmartMedia on a
computer's FDD (Floppy Disk Drive). (For FDDs with 1.44
MB support only)
e The FlashPath is the same size as a 3.5-inch floppy disk. It
allows SmartMedia to be read and written on the FDD.
e The FlashPath operates on IBM PC/AT or compatible
computers on which a Microsoft Windows 95/98/NT4.0
operating system (OS) must be installed and operating
properly. For details, refer to "Computer Operating
Environment" on page 2.
e Do not subject the unit to vibrations or shocks while data is
being written onto or read from the SmartMedia. Doing so
may result in damage to or loss of the internal data.
e Do not remove the FlashPath or SmartMedia or turn off the
power while data is being written or erased. Doing so may
result in loss of the data or damage to the SmartMedia.
e Do not remove the FlashPath while the FDD is operating.
Doing so may result in loss of the data or damage to the
SmartMedia.
e Note that the FlashPath does not recognize write protect
seals on the SmartMedia. Be careful not to erase or
overwrite the data by mistake.
e The data is lost when the SmartMedia is formatted. Check
that the SmartMedia contains no important data before
formatting it.
e The FlashPath may not function for some makes of FDDs. It
will also not function when the FDD is connected with an
interface other than the normal interface. For example, the
~ FlashPath cannot be used with external FDDs connected
via a PC card, with FDDs connected using USB, or with
high storage capacity FDDs (120 MB, etc.).
e To protect the FlashPath and the FDD, remove the
FlashPath from the FDD after using it. When transporting
the FlashPath or not using it for long periods of time, be
sure to remove the SmartMedia and store the FlashPath in
its Case.