Installation Requirements; Location Requirements; Electrical Requirements - Whirlpool LRF4001RY Use And Care Manual

Location Requirements

WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from fabric freshener.
Place fabric freshener at least 18 inches (46 cm) above
the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
The Fabric Freshener will require an area large enough to set up
the Fabric Freshener and to load.
12"
(30.48 cm)
Installation Clearances
Minimum clearances
Sides and back of the Fabric Freshener
0" (0 cm) clearance is acceptable.
Front of the Fabric Freshener
12"(30.48 cm) clearance is recommended.
4

INSTALLATION REQUIREMENTS

57 "
(145.1 cm)
32 "
(82.55 cm)

Electrical Requirements

WARNING
NEW 2 PRONG PANEL
Fire Hazard
Do not use an extension cord.
Doing so can result in death, or fire.
Electrical Connection
To properly install your Fabric Freshener, you must determine the
type of electrical connection you will be using and follow the
instructions provided for it here.
The Fabric Freshener should be connected to a 120 volt,
60 Hz, 15- or 20-amp fused 2 prong polarized outlet.
Electrical consumption: at $0.04 (approximate) per cycle,
150 cycles per year = $6 per year (approximate). Usage and
costs may vary.
The Fabric Freshener uses just under
draw is limited to 80% of a 15-amp circuit, or 12 amps, at
120 volts. 80% is equal to 1,440 watts of 1,800 watts
available on a 15-amp circuit. If house wiring is less than
120 volts, available wattages may be lower. Usage and costs
may vary.
kwh. Maximum amp