Whirlpool RY160LXT Installation Instructions Manual page 7

■ Lift range back panel up and off.
■
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
■ Position cord/conduit plate as shown in the following
illustration.
■ Replace cord/conduit plate and insert screws.
E TAG! E TAG! USE CORD CORD USE CORD
REMOV WITH WITH REMOV WITH POWER POWER POWER ETIQUE ETIQUE AS TA TA
NUTS NUTS NUTS QUITE USE QUITE LA LAS CONEC LA CONEC TAR TAR TUERC ICO EL EL ICO
PARA CORDÓ PARA CORDÓ N ELÉCTR N ELÉCTR
■ Assemble a UL listed conduit connector in the opening.
A. Removable retaining nut
B. Strain relief
■
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be
connecting to:
4-wire receptacle A UL listed,
(NEMA type 14-50R) 250-volt
minimum,
40-amp, range
power supply
cord
4-wire direct A fused
disconnect or
circuit breaker
5"
box
(12.7 cm)
3-wire receptacle A UL listed,
(NEMA type 10-50R) 250-volt
minimum,
40-amp, range
power supply
cord
3-wire direct A fused
disconnect or
1"
(2.5 cm)
circuit breaker
box
3"
(7.6 cm)
A
B
Go to Section:
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
3-wire connection:
Power supply cord
3-wire connection:
Direct wire
7