Samsung HG55TS030AJ Quick Setup Manual

Quick Setup Guide
To register this product please visit www.samsung.com
1. List of Parts
• The provided accessories may vary depending on the model.
1 2
Samsung Smart Remote & Batteries
Power Cord
(AA x 2)
4 5
Warranty Card / Quick Setup Guide / Regulatory
One Invisible Connection
Guide (Not available in some locations)
7 8
AV IN Adapter
Antenna adapter
(Not available in some locations)
2
3 4
2. The Samsung Smart Remote
Pairing the TV to the Samsung Smart Remote
-00
3 When you turn on the TV for the first time, the Samsung Smart Remote pairs to the TV automatically. If the Samsung
Smart Remote does not pair to the TV automatically, point it at the remote control sensor of the TV, and then press and
hold the buttons labelled and
• The Samsung Smart Remote can only be paired to one TV at a time.
Installing batteries into the Samsung Smart Remote
One Connect
6
x 4
Wall Mount Adaptor
(65": Not available)
9
To install the batteries, push the rear cover open in the direction of the arrow at the bottom of the illustration, and
then insert the batteries as shown in the figure. Make sure that the positive and negative ends are facing in the correct
direction. Close the rear cover as shown.
• Alkaline batteries are recommended for longer battery life.
Bending Cover
5
One Connect
NOTE
• Make sure to distinguish between the front and back of each component when assembling them.
• Make sure that at least two persons lift and move the TV.
as shown in the figure on the left simultaneously for 3 seconds or more.
10 cm
3. Installing the LED TV Stand
Assembling the Stand, Components and One Invisible Connection
When installing the stand, use the provided components and parts.
Stand Holder-Cable
1
L
R
• Place a soft cloth over the table to protect the TV, and then place the TV so that its screen faces down toward the
table surface.
• Insert the Stands into the slot on the bottom of the TV.
• Slide and assemble it to the end line in the direction of arrow.
4. Viewing the One Connect