Advertisement
6.
Install the armrest to the seat using the 2
flange bolts and flange nuts that you removed
previously
(Figure
Figure 8
1. Armrest
2. Armrest bracket
7.
Connect the wire harness to the seat:
•
For the standard seat: Connect the
connector on the short wire harness to the
open port under the seat.
•
For the premium seat:
A.
Cut the cable ties securing the seat wire
harness to the back of the seat.
B.
Adjust the seat as far back as possible
and plug the seat harness into the short
wire harness.
C.
Cable tie the wire harness to the corner
of the seat where the original ties were
cut.
•
For Triflex machines: use cable ties to
secure the wire harness to the choke/throttle
cable.
8).
3. Flange bolt
Operation
Seat Controls
Seat-Adjusting Lever
The seat-adjusting lever is located on the front, left
corner of the seat
allows you to adjust the seat forward and rearward.
g277239
1. Seat-adjusting handle
Note:
If you need additional adjustment on the seat,
g015250
remove the 4 bolts securing the seat to the rails and
move the seat to the second set of mounting holes
provided
(Figure
Note:
If you need additional adjustment to the
armrest, loosen the hardware securing the armrest
and move adjust its position
4
(Figure
9). Twisting the handle up
Figure 9
4).
(Figure
8).
g193737
Advertisement
