Using The Trimmer - Panasonic ES4033 Operating Instructions Manual

Using the trimmer
Shaving longer, curly hair under
the chin
(Sea fig. 44)
Slide the trimmer switch up. Place
the trimmer al a right angle to your
skin and move it outward to trim long
hair and curly hair. Make sure that
the trimmer is facing outward away
from the neck.
Trimming sideburns (see fig. 48)
Slide the trimmer switch up. Place
the trimmer al a right angle to your
skin and move it downward to trim
sideburns.
Cleaning your shaver
(See fig. 5)
Waming- То prevent electric shock
or personal injury disconneci the
tum the shaver off before
For cleanliness and convenience, we
recommend that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep
your shaver in good condition while
preventing одогв or bacteria form
developing, and maintain the cutting
performance. With the system outer
foil in place, apply some hand soap
onto the outer foil. Turn the shaver
on and pour some water over Ihe
outer foil. After about 10-20 seconds.
Remove the outer foil and clean it
with running water. Wipe off any
moisture from the shaver with a dry
cloth and remove the protective cap
to allow the system outer foil to dry
completely.
Replacing shaving head
components
With daily use, it is recommend thal
you replace the outer foil at least
every year and the inner blade al
laast every two years to maintain
your shaver's cutting performance.
Replace the outer foil
(see fg.)
Squeeze the outer foil release buttons
and lift the outer foil upward to remove
it To insert the new outer foil, press
down until it snaps into place.
Replace the inner blades
(See fig. 7)
Squeeze the foil frame release
buttons and lift the foil frame upward
to remove it. Remove the inner
blades, one at a time, by grasping
them firmly at both ends and pulling
straight away from the shaver. To
insert the new inner blades, hold the
blades, one at a time, at both ends
and press downward until they snap
into place.
For environmental protection
and recycling of materials
This shaver contains Nickel
cadmium battery. Please make sure
that the battery are disposed of
at an officially assigned location, il
there is one in your country.
Caution
* Do not charge the shaver where
the temperature is below OFC (32°
F) or above 40* C(104* F), where
it will be exposed to direct sunlight
or a heal source, or where there is
a lot of moisture.