Add Fingerprint - Lenovo smart lock U1 User Manual

2 : ENTER TO ADMINISTRATOR MODE
3 : USER SETTING
Enter the user setting mode, to add user fingerprint, password and card and select the operation
below according to the unlocking method you need to add.

3.1 : ADD FINGERPRINT

a. Press [*] twice to enter management mode, press [1] to enter the user setting mode, and then
press [1] to add user fingerprint.
b. Input the user number that needs to add fingerprint, and press [#] to confirm.
c. Place the fingerprint to be added on the fingerprint collector, when you hear "please take away
your finger and put it again" take away your finger and put it back into the fingerprint area five
times and when you hear "add successfully", the user fingerprint wil be added successfully.
CAUTION
When recording fingerprints, it is recommended to collect fingerprints from multiple angles up and down,
left and right.
3.2 : ADD PINCODE
a. Press [*] twice to enter management mode, press [1] to enter user setting mode, and then press
[2] to add user Pincode.
b. Input the three-digit user numbers, and press [#] to confirm.
c. Enter the 6-8 digit door unlocking pincode you want to add and press [#] to confirm, and then
input the door opening pincode again and press [#] to confirm. It would be completed when you
hear the voice prompt "add successfully".
a. Touch the key area, and then the keyboard light will be on.
b. First press [*] twice, then enter the management password, and then
press [#] to confirm.
c. Voice prompt: "You have entered the management mode".
d. Under the factory default, there is no administrator. In such a case
when using the lock for the first time, the user needs to add the
management password.
CAUTION
If the identification of the administrator fails, it will give a voice "input error".
If the identification is successful, directly enter the main menu, press the [*]
key to exit,press the corresponding number to enter the sub-menu.