Samsung DW80H995 Series Installation Manual page 21

STEP 12 COMPLETING THE iNSTALLATiON
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation,
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher
_is operating, tf no problem is found, turn off the dishwasher, and then go to Step 5 below.
If you encounter a problem, turn off the dishwasher, close the water supply valve, and then
refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).
Make sure to check for water leakage on both ends of the water supply line and drain hose
OAOT,O. connector.
5. Locate the sound absorber in front of base refer to the figure below (ON SOME MODELS).
[_ heck it the black rubber skirt (*applicable models only) should be located inside, and then
sound absorber will be covered it.
i
/
6. Confirm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,
refer to the fi gure below.
installing the dishwasher 21
D1,*Tg0H9950US 00151A 06 EN 150216illdd See3:21