Software; Simcenter Scadas Rs Recorder App And Configuration App; Simcenter Testlab Neo; Firmware Updates - Siemens Simcenter SCADAS RS User Manual

Table of Contents

15. Software

Every unit comes with software embedded on the device. It does not require any installation and

it is accessible through any web browser (on PC, tablet, smartphone). The Simcenter SCADAS RS

Configuration App is intended to configure units.

The Simcenter SCADAS RS Recorder App can be used for data acquisition and on-board calculations

and track-side data validation. For advanced data acquisition and analysis, use Simcenter Testlab Neo

application software.

Full information can be found in the User Manual of the Simcenter SCADAS RS Recorder App and

Configuration App.

Simcenter Testlab Neo is a complete, integrated software solution for advanced data acquisition and

analysis. With its unique workflow-based interface, it sets new standards for ease-of-use, productivity,

data acquisition, advanced data analysis and data consistency.

The key features of Simcenter Testlab Neo for Road load acquisition, analysis and reporting, are fast and

accurate configuration, synchronized recording, streamlined analysis and actionable reports.

Full information can be found in the SCADAS RS Recorder App documentation.

When new firmware is available, it must be uploaded to the REC Unit using the Simcenter SCADAS RS

Recorder App, using the SCRSA-CABN02 (REC to PC) cable accessory.

In order to upload firmware on other units, the SCRSA-CABN01 (daisy chain to PC) cable accessory is also

required.

Full information of this procedure can be found in the SCADAS RS Recorder App User Manual.

Simcenter SCADAS RS firmware, including embedded Simcenter SCADAS RS Recorder App, and

Simcenter Testlab Neo can be downloaded from: https://support.sw.siemens.com