Care And Maintenance; Optional Accessories - DeWalt DXF1616 Instruction Manual

4. Fan Location: Place the fan in an area in
the room that will provide the most effective
air circulation.
5. Fan Connection: Plug fan directly into
120 volt A.C., 60Hz wall outlet. Be sure plug
cause overheating and damage to the plug
or fan.
NOTE: To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
6. Turning Fan On: Place fan on stable
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
7. Turning Fan Off: To turn the fan off, turn
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
8. Adjusting Fan Tilt: Loosen the
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.
SUSPENDING/MOUNTING
THE FAN
CAUTION: When the fan hangs by the
hang hooks, do not shake the fan or the
object from which it hangs. Do not hang
the fan from any electrical wires or anything
that is not secure. Personal injury or property
damage may occur.
CAUTION: Only use the hang hooks for
hanging the fan as shown in Fig. A. The hang
hooks are not intended to support additional
weight. Do not attach or hang anything
additional to the fan or risk of breakage
may occur.
CAUTION: Do not use the hang hooks to
reach with or to support your weight in any
situation.
CAUTION: Do not stand underneath the
fan when it is mounted overhead. Serious
personal injury or damage to the fan may
result if the fan falls.
CAUTION: Do not mount the fan to
the ceiling.
NOTE: Locate the fan away from a corner
or other obstructions which may impede
air ow.
Your jobsite fan has multiple options
for mounting.
HANG HOOK
The built-in hang hooks telescope out of the
back legs and can be used to suspend the
fan from 2X lumber as shown. Be sure to fully
extend the hooks before using, then rotate as
needed.

CARE and MAINTENANCE

Cleaning:
W ARNING:
Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
W ARNING:
DO NOT IMMERSE THE FAN
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
before use. Periodic grille cleaning with a
vacuum will prevent dust build up. The motor
is sealed and does not require any interior
maintenance, cleaning or lubrication.
Maintenance: The Internal motor bearings
are permanently lubricated at the factory and
do not require any additional lubrication.
Repair:
W ARNING:
DO NOT OPERATE THE FAN
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage
of the fan. Coil and tie the power cord to avoid
damage during storage.
Free warning label replacement: If
warning labels become illegible or are missing,
please call 1-888-899-0146 for free
replacement.

OPTIONAL ACCESSORIES

W ARNING:
Since accessories, other than
those offered by D WALT, have not been
E
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D WALT recommended accessories should be
E
used with this product.
ENGLISH
Fig. A
5