Operation - Husqvarna DC 900 Operator's Manual

area and appropriate action taken to prevent dust
dispersal.
• The outside of the machine should be
decontaminated by vacuum cleaning methods and
wiped clean or treated with sealant before being
taken out of a working area.
• For user servicing, the machine shall be dismantled,
cleaned and serviced, as far as is reasonably
practicable, without causing risk to the maintenance
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
WARNING:
injury, make sure that you attach the product
plug fully to the extension cable. Do regular
checks of the connection while you operate
the product to make sure that it is fully
attached. Do not use an extension cable that
makes a loose connection.
WARNING:
manual of the attached equipment carefully.
If specified requirements or settings are
given for the secondary product, make sure
that you obey these.
2154 - 002 - 25.10.2023

Operation

Before you operate the
To prevent the risk of
Read the operator's
staff and others. Suitable precautions include
decontamination before dismantling, provision for
local filtered exhaust ventilation where the machine
is dismantled, cleaning of the maintenance area and
suitable personal protection.
• It is necessary to provide for an adequate AIR
CHANGE RATE ACR in the room if the exhaust
air is returned to the room. Refere to National
regulations.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 14 .
3. Make sure that the work area is clean and bright.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
5. Make sure that the product is installed correctly.
6. Make sure that the frequency and voltage shown on
the type plate agrees with the power supply voltage.
This is also applicable for the extension cables.
7. Engage the parking brake. Refer to
disengage the parking brakes on page 10 .
8. Connect the air hose and the power cord of the fan
unit to the primary unit.
9. Attach the 2 dust extraction hoses. Refer to
attach the dust extraction hoses on page 10 .
10. Install a BigBag. Put a pallet below the BigBag.
11. Make sure that the power plug is connected
correctly.
Maintenance
To engage and
To
9