Dismounting - Suzuki GA413 Manual

1. Back-up light switch
2. Back-up light switch coupler
3. Speed sensor
4. Clamp
1. Clutch cable end
2. Clutch release fork
1. Control cable end clip
2. Control cable rear washer
3. Gear shift control cable assembly
1. Stiffner

DISMOUNTING

1) Disconnect negative (–) cable from battery terminals and hoist
2) Disconnect back-up light switch lead wire at coupler.
3) Disconnect Black/Yellow lead wire and positive (+) cord from
4) Disconnect coupler from speed sensor and free its harness
5) Remove drain plugs to drain oil in transmission.
6) Remove transmission upper case cap and take off clutch cable
7) Remove body ground cable bolt.
3. Clutch cable
4. Ground cable bolt
8) Remove control cable end clips and washers, and then discon-
9) Remove gear shift and select control cables from bracket.
4. Gear select cable
assembly
5. Control cable bracket
10) Remove front and rear propeller shafts referring to "PROPEL-
11) With transmission supported on jack, remove stiffner.
vehicle.
starting motor. Remove starting motor from transmission case.
from transmissions.
end from clutch release fork. Disconnect clutch cable assem-
bly from transmission.
nect gear shift cable and select cable from each lever.
LER SHAFTS" section.
MANUAL TRANSMISSION (4WD) 7A1-5