SolaX Power X3-Hybrid-5.0-D User Manual page 67

Troubleshooting
Number
CellImblance
BE 09
BE 10
BMS_Hardware
BE 11 BMS_Circuit
BE 12 BMS_ISO_Fault
BMS_VolSen
BE 13
BMS_TempSen
BE 14
BE 15 BMS_CurSen
BMS_Relay
BE 16
TypeUnmatch
BE 17
Ver Unmatch
BE 18
BE 19 MFR Unmatch
BE 20 SW Unmatch
M&S Unmatch
BE 21
CR NORespond
BE 22
BE 23 SW Protect
536 Fault
BE 24
BMS SelfCheck
BE 25
128
Battery Unbalanced Failure
• Please contact the battery supplier.
Battery hardware protection failure
• Please contact the battery supplier.
Battery circuit failure
• Restart the battery .
• Please contact the battery supplier.
Battery insulation failure
• Check that the battery is properly grounded and restart the battery
• Please contact the battery supplier.
Battery voltage sensor fault
• Please contact the battery supplier.
Temperature sensor failure
• Restart the battery .
Please contact the battery supplier.
•
Battery current sensor fault
• Please contact the battery supplier.
Battery relay failure
• Please contact the battery supplier.
Battery type failure
• Upgrade the battery BMS software.
• Please contact the battery supplier.
Battery version mismatch failure
• Upgrade the battery BMS software.
Please contact the battery supplier.
•
Battery
manufacturer did not match the fault
• Upgrade the battery BMS software.
• Please contact the battery supplier.
Battery hardware and software mismatch failure
• Upgrade the battery BMS software.
• Please contact the battery supplier.
Battery master slave control mismatches
• Upgrade the battery BMS software.
Please contact the battery supplier.
•
Battery charging request does not respond to a fault
• Upgrade the battery BMS software.
• Please contact the battery supplier.
Battery slave software protection failure
• Upgrade the battery BMS software.
• Please contact the battery supplier.
Battery fault-discharge over current fault
• Please contact the battery supplier.
Over temperature in battery system
• Please contact the battery supplier.
Number
BE 26
BE 27
BE 28 BMS_FlashFault
BMS_Precharge
BE 29
.
AirSwitchBreaker
BE 30
If the information panel of your inverter does not show the fault light,
check the following list to ensure the current installation status, correct
operation.
------
Is the inverter located in a clean, dry and well-ventilated place?
------
Is the DC input circuit breaker open?
------
Is the specification and length of the cable adequate?
------
Are the input and output connections and wiring in good
condition?
------
Is the configuration set correct for your particular installation?
Please contact customer service for further assistance. Please be prepared
to describe the details of your system installation and provide the
inverter serial number.
Battery temperature sensor malfunction
BMS Tempdiff
Please contact the battery supplier.
•
Battery Unbalanced Failure
BMS_BreakFault
• Please contact the battery supplier.
Battery hardware protection failure
• Please contact the battery supplier.
Battery precharge failure
• Please contact the battery supplier.
Battery air switch failure
• Check that the battery breaker is off.
• Please contact the battery supplier.
Troubleshooting
129