1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
4 Disassembly and Assembly Instructions 4.1. Disassembly Instructions Follow the procedure below to disassemble the main unit. 1. Remove the cap, the outer foil with foil frame and the 4. To remove the trimmer driving bar, press bar outward. inner blade. 2.
Page 5
6. Loosen two screws. Take out the retaining plate and 8. Take out the motor and the battery & module assembly waterproof rubber with care of breakage. Loosen six gently from housing A. screws. NOTE: Do not lose the washer and O-ring. NOTE: Do not lose the screw O-rings.
Page 6
4.2. Assembly Instructions NOTE: Make sure whether there is NO foreign substance sticking around a part covered with waterproof seal. 1. Install the driving A in the motor mounting base after 4. Set the housing A and B and tighten 6 screws. And inserting the motor tip pin into the hole of armature 1 of attach the side panels and tighten a screw on bottom.